FlameMind
Sign in

← Explore

PSI-62

PSI-62PreventionNeeds review

Concurrent Flame Spread Modeling using Flamelet Generated Manifolds in Microgravity with Comparison to BASS Experiments using Two-Color Tomography

View raw data on PSI ↗

Needs review: this record is flagged for a manual check. Confirm values against the linked sources before relying on them.

Objectives

  • The objective of this research was to develop and validate new flamelet generated manifold (FGM) modeling techniques for concurrent flame spread in microgravity. Concurrent flame spread presented one of the greatest modeling challenges in combustion science due to the intricate coupling between heat transfer, mass transport, and chemical kinetics near the solid-vapor interface. Traditional modeling strategies often relied on hybridized turbulence and chemistry models that were not fully consistent and failed to capture important intermediate reaction pathways. To overcome these shortcomings, this PSI grant advanced the use of an unsteady flamelet generated manifold (UFGM) framework that reduced the complexity of reacting systems by mapping them into lower-dimensional manifolds. The research aimed to leverage this methodology to simulate solid fuel combustion processes with high fidelity, using the NASA Burning and Suppression of Solids (BASS and BASS-II) experiments as benchmarks. Ultimately, the long-term goal was to enable accurate prediction of flammability limits for spacecraft materials and to provide a tool that could also serve as a subgrid-scale model in large-eddy simulations of fires, supporting spacecraft safety and hazard mitigation.

The approach combined high-resolution computational modeling with experimental validation to study concurrent flame spread in microgravity. A previously developed computational framework was employed to run fully coupled simulations of fluid–solid responses, focusing on materials subject to charring and ablation. Within this framework, the unsteady FGM method was implemented and tested on various BASS geometries, including flat sheets, spheres, and rod-shaped polymethyl methacrylate (PMMA) samples, as well as wax cylinders. Experimental imagery found in PSI from the BASS and BASS-II investigations was post-processed using newly developed two-color tomography methods with DSLR cameras, enabling 3D reconstructions of soot and temperature fields for direct comparison to model predictions. The evaluation metrics included flame geometry, temperature distribution, soot volume fraction, and flame spread rate, with special emphasis on reproducing the “Goldilocks” flammability zone reported by Olson and Ferkul. Comparative analyses were also carried out with a parallel NSF-supported terrestrial flame spread project, ensuring that the predictive capabilities of the UFGM approach were assessed across both microgravity and normal-gravity conditions.

Conditions

ParameterTested value or rangeUnit
Oxygen–% by volume
Pressure–psi
Pressure–kPa
Airflow–cm/s
Gravity–
Diluents–
Fuel phase–
Fuels–
Sample geometry–
Sample size–as stated
Hardware–
Platform–
Years2019-2021

A dash means the sources do not state the value.

Variables varied

None recorded.

Variables held fixed

None recorded.

Sensors

None recorded.

Findings (0)

No findings are recorded for this investigation.

Tests (0)

No individual tests recorded

The sources for this investigation do not list separate test samples.

Sources (1)